Posted on 2016-11-24 by Author Admin
One of the simplest ways to keep your garage door tracks aligned is the proper and regular maintenance. It helps to extend the life of the tracks, rollers, hinges, springs and the door opener. If not maintained on a regular basis, your garage door might suffer from situations like dragging, and binding. If you recognize any sort of problem while operating the door, the first step you should do is to inspect the door carefully and identify the source of the issue. If your door is electrically operated, switch-off the power and pull the emergency cord to disconnect the opener from the garage door. If you have any kind of trouble while operating the door, it needs professional help.
How the Tracks and Rollers Work Together
Garage door tracks need to be properly clean and lubricated for smooth functioning. The tracks are connected to the doors with the help of metal clips. These tracks act as a guide to the rollers, and therefore, proper alignment is needed so the rollers do not go off-track. The metal clips have unique slots for side adjustments. The rollers go off-track when the tracks are too close to the door.
Read More: Why the Automatic Garage Doors may not respond to Remotes
Steps to align the Tracks
- Loose one track at a time and do not remove the lag bolts completely. Slide the bracket until you find the correct position. Tighten the bolts, when the tracks are placed correctly.
- Another way is to align the track margins of the garage door. The tracks should be parallel, while the door is resting on the ground to achieve the full height of the door.
- The lag bolts and the brackets are connected to each other. The brackets have a hole that allows side to side movement. You might need to loosen two brackets at a time depending on the situation in order to bring them in the desired position.
- To achieve the consistent margins, adjust the brackets until you are able to see or of the shaft.
Aligning the Overhead Track
- The overhead track has only one adjustment point. The distance between the wall track and the overhead track must be the same and the door shouldnt be up while performing the task.
- Loose the bolts or remove them from the holes if new adjustment is required. Do not move the track far away or too close to the door as it might fall or bind respectively.
- Adjusting the overhead tracks is almost similar to the procedure followed in side track adjustments. The only difference is the overhead track has only one slot where it gets a fix.
- The ends of the door tracks are attached to the metal angles that are held by the rafters or ceiling. The objective of the holes present in it is to run the tracks parallel.
Must Read: 3 Reasons Why Garage Door Closes Very Quickly, Often With a Bang
The Bottom Line
Aligning the tracks and the overhead tracks is not an easy task. It must be performed under the professional guidance. They are well-trained and certified to perform the task in a safe manner. The alignment problems if not corrected in a proper way may cause severe accidents and injuries. Therefore, if you are not sure while repairing the tracks, call professionals for help.